+86 13676951397 info@bestshuliy.com

Installation and maintenance of sawdust charcoal briquette production line

The maintenance of the sawdust charcoal briquette production line is extremely important and regular work. It should be closely coordinated with the operation and maintenance of the machine. There should be full-time personnel on duty inspection.

Maintenance of sawdust charcoal briquette production line

sawdust charcoal briquette production line

1. Bearing: The shaft of the crusher bears the full load of the negative machine, so good lubrication has a great relationship with the bearing life. It directly affects the service life and operation rate of the machine. Therefore, the required oil must be cleaned and the seal must be cleaned. Good, in the main oil filling part of the machine (1) rotating bearing (2) roll bearing (3) all gears (4) movable bearing, sliding plane.

2. The newly installed tires are prone to loosening, so it is necessary to check frequently.

3. Pay attention to whether the work of all parts of the machine is normal.

4, pay attention to check the wear level of wearable parts, always pay attention to replace the worn parts.

5. Place the bottom plane of the movable device, and the dust should be removed to prevent the movable bearing from moving on the chassis when the machine encounters unbreakable materials, resulting in serious accidents.

6, the bearing oil temperature rises, need to stop immediately for an inspection.

7. If there is impact sound when the rotating gear is running, it needs to stop the inspection immediately and eliminate it.

Installation test of sawdust charcoal briquette production line

1. The equipment should be installed on a level concrete foundation and fixed with anchor bolts.

2. When installing, pay attention to the vertical direction of the main body and the horizontal.

3. After installation, check whether the bolts in all parts are loose and the main door is tight.

4. Configure the power cord and control switch according to the power of the device.

5. After the inspection is completed, the empty load test is carried out, and the test can be carried out normally.




Related articles

[]
1 Step 1
keyboard_arrow_leftPrevious
Nextkeyboard_arrow_right